Notifications
Clear all
First Layer Calibration Y axis not moving
Hello I recently upgraded my mk3s to a mmu2s. I followed all of the directions carefully and have everything set up the way it should be. I can calibrate the z axis just fine and it works however when I calibrate the first layer the bed will not move along the y axis for the printer to auto home. Any suggestions would be much appreciated
Publié : 08/11/2019 3:24 pm
Topic starter
answered:
RE: First Layer Calibration Y axis not moving
Also whenever I try to selftest the printer everything works fine up until the Y axis has to move. Then it says "Please check: Axis length Axis Y"
Publié : 13/11/2019 2:26 pm