First layer calibration fail
I have Original Prusa i3 MK3S, Printing with e-sun PLA+.
I tried all the range of heights without success. I also changed the nozzle with new one, didn't help.
Corners and small circles are terrible as shown.
What could be the issue with this type of failure?
Best Answer by Sam:
The plate wasn't clean. Cleaning it with alcohol wasn't enough. I had to wash it under running water and soap. Now it works like a charm
RE: First layer calibration fail
The plate wasn't clean. Cleaning it with alcohol wasn't enough. I had to wash it under running water and soap. Now it works like a charm
RE: First layer calibration fail
Welcome to the weird world of 3D printing, Sam
I am pleased that you resolved the issue...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK