Notifications
Clear all
Filament changes MMU2 Single
When I slice, then add a filament change, I noticed the printer doesn’t wipe the nozzle before continuing. Is there a setting I’m missing?
Thank you for your feedback.
Posted : 01/03/2023 7:24 pm
RE:
Too short, wrong sub forum, missing important information, like project file. Answer is: Probably yes, you are.
You are welcome.
PS. If you want a wipe tower, you need to slice in MMU-mode, not in single-mode
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Posted : 03/03/2023 10:04 am