RE: Emergency Stop: Error M112
@bobstro
Yes. I used octoprint but got the same error from an SD card.
--------------------
Chuck H
3D Printer Review Blog
RE: Emergency Stop: Error M112
@charles-h13
Do you still have the M112 problem after the factory reset?
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Emergency Stop: Error M112
@karl-herbert
No.
--------------------
Chuck H
3D Printer Review Blog
RE: Emergency Stop: Error M112
@charles-h13
Thank you! I have been working with Octoprint (1.3.10) for over 2 years and have never had a problem with a m112 emergency stop. Since the system is stable, I will not upgrade the system or octoprint any further. My printer is also not online and therefore I have no security worries.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Emergency Stop: Error M112
@bobstro
M900 is no a part of my startup code, but it is a part of my end G code.
I have M900 in my filament custom g-code (and this is what I change when tuning LA for a particular filament), not in the printer custom g-code.
See my (limited) designs on:
Printables - https://www.printables.com/@Sembazuru
Thingiverse - https://www.thingiverse.com/Sembazuru/designs
RE: Emergency Stop: Error M112
I replaced my thermistor and heater cartridge on my mosquito. It seems to happen less now. It may be a coincidence.
--------------------
Chuck H
3D Printer Review Blog