Notifications
Clear all
Cold pull pic's of gap between nozzle and heat break
any one have cold pull pic of when there is a gap between nozzle and the heat break, where the gap might causes leaks. I have done some cold pulls for both scenarios but not quite sure i am looking for some thing specific, just recently learned that i can do a cold pull to see if the nozzle an heat break are sealed.
some of my cold pulls are straight, but the one i did with gap is more bent but not sure if that is because i pulled it out differently or not?
here are some i have done in the past 
Ce sujet a été modifié il y a 5 years par muo
Publié : 09/05/2020 7:47 pm