Avisos
Vaciar todo
Chief Architect model
Working on printing STL files imported from Chief Architect.
I exported a file of just the floor plan & also a file with the roof on (both attached).Commercial1-1All
It appears that neither has a printable 1st layer, so I adjusted the Z down a bit to sink it into the plate - good so far.
However, the slicer doesn't seem to acknowledge the roof. Any ideas would be helpful.
Thanks in advance.
Respondido : 01/05/2022 3:31 am
RE: Chief Architect model
Lots of errors and it would appear that the version with a roof is not in mm. Tried to fix errors but roof still not printed.
Respondido : 01/05/2022 10:06 am