Notifications
Clear all
Can I disconnect the MMU and just single feed the filament?
I have a Prusa MK4S with a MMU3 attachment. It appears that my selector motor has taken a crap so the MMU3 is out of commission. I still would like to print until I get it fixed. Can I disconnect the MMU and just single feed the filament to the printer until the motor arrives? Has anyone done this?
Posted : 05/12/2025 8:26 pm
RE: Can I disconnect the MMU and just single feed the filament?
Just disconnect the PTFE tube leading from MMU to nextruder and disable MMU in the printer settings. Then you can just work as the mmu was never connected....
Posted : 05/12/2025 8:45 pm