Notifications
Clear all
Bug Report
Hey guys, where would I submit a bug report? I noticed that when uploading gcode, when using the nozzle size selector, no matter what value I choose, it always saves 1mm.
Here's a short screencapture:
This topic was modified 3 years ago by Tessa
Posted : 12/02/2021 11:58 am
RE: Bug Report
@tessa-2
Welcome to the, er, charming eccentricities, of the forum software.
There is a feedback thread for the forum here:
https://forum.prusa3d.com/forum/general-discussion-announcements-and-releases/test-2
Sometimes we even get a few results, sometimes.
Cheerio,
Posted : 12/02/2021 4:14 pm