anybody ever get a bad roll of prusa filament?
 
Notifications
Clear all

anybody ever get a bad roll of prusa filament?  

  RSS
maladjustedmind
(@maladjustedmind)
Active Member
anybody ever get a bad roll of prusa filament?

i have a mk3s, i only use prusa filament and i have a roll of jet black pla that i cant even get a good first layer cal out of. i can swap to any other roll of prusa pla i have and its fine. is the jet black a bit different or maybe its just a bunk roll? i keep all my filament in sealed bins with dry packs and my room temp and humidity are normal. any advice ? maybe its a print setting i can adjust? im still rather new to printing. any help appreciated 🙂

Posted : 02/01/2021 3:31 pm
Peter M
(@peter-m)
Noble Member
RE: anybody ever get a bad roll of prusa filament?

Picture?

And what did you try yourself to get it working?

Every filament could be different, adjusting settings for this is normal.

Posted : 02/01/2021 7:38 pm
Hmidouch
(@hmidouch)
New Member
RE: anybody ever get a bad roll of prusa filament?

hello  maladjustedmind, what did you attempt yourself to make it work?

Posted : 03/01/2021 4:58 pm
Share: