Notifiche
Cancella tutti
Ambient or Build Volume Temperature Placeholder
Hi
I have an enclosed 3D printer that has a heater for the build volume.
I haven't seen a placeholder in PrusaSlicer, is there one or one planned. I realise I could use a macro based on say bed temperature, but it'd be better to have a specific one.
Many thanks
Mike
Postato : 09/01/2021 9:07 am
Topic starter
answered:
RE: Ambient or Build Volume Temperature Placeholder
No worries, I sorted it by making a filament custom start code, and it works really well, & if you do make an enclosed FDM printer one day, then it's just another placeholder in the filament configuration. 🙂
Postato : 12/01/2021 9:35 pm