Notifications
Clear all

Amazon basic PLA filament  

  RSS
Florian Kals
(@florian-kals)
New Member
Amazon basic PLA filament

I have significant problems with a roll of red amazon basic pla filament. It sticks to the builtplate at first but starts warping after a few millimeters of height. 

Has anyone experienced this so far? I tried other cheap pla filaments with printing the same models after the fails and they worked out well.

It really seems like the filament is bad in this case. I watched the benchy at first and also saw the pla warping up on the front side of the boat and it sticked to the builtplate until this happened.

Posted : 06/01/2022 5:17 pm
Share: