Notifications
Clear all

Adding MMU2 to MK3S+ problems  

  RSS
Paulgs
(@paulgs)
Active Member
Adding MMU2 to MK3S+ problems

I was unable to start my printer after adding the MMU (the unit would start, light up, and then the screen would go dark. I took the unit back to the MK3S+ and noticed that I did not move the sensor cable to the top slot. The same thing happened when I tried to start the printer. (The display lights up then immediately go dark). Did I blow the sensor?

Posted : 24/02/2022 9:35 pm
Share: