The Child (baby Yoda).
Printed a few of these in white PLA at 0.10 mm detail on my MK3S. Just painted one today.
Can't remember where I got the stl, it was a few months back, just got around to printing it.
Hadn't used my airbrush in months and it was not working well, so the paint job could be better. I tore it apart, cleaned and lubed it, so I might go back over it again.
RE: The Child (baby Yoda).
I guess it's this one: https://www.myminifactory.com/object/3d-print-the-child-baby-yoda-105405
Having problems with bed adhesion every morning...
RE: The Child (baby Yoda).
Printed a few of these in white PLA at 0.10 mm detail on my MK3S. Just painted one today.
Can't remember where I got the stl, it was a few months back, just got around to printing it.
Hadn't used my airbrush in months and it was not working well, so the paint job could be better. I tore it apart, cleaned and lubed it, so I might go back over it again.
Very nice and good idea! Did you print with support? Which filament material and which colours (synthetic resin, 2k..) did you use?
Thanks!
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: The Child (baby Yoda).
@karl-herbert
Yes, the hands require supports since they curve downward.
I did this months ago so don't remember what brand PLA, I think in white all I have around is the Inland stuff from Microcenter so it was most likely that.