Notifications
Clear all

Some of my prints  

  RSS
Veszmadar
(@veszmadar)
Active Member
Some of my prints

Some egg cups for my girlfriend:

Headphones holder

Cable holder

The Witcher medal (the teeths are missing 🙂 Its an old wolf... )

A vase

Paste tube pusher

Opublikowany : 27/09/2015 6:54 pm
Josef Průša
(@josef-prusa)
Member Admin
Re: Some of my prints

Oh sweet 🙂 What materials did you use for those prints?

Founder and owner / Majitel a zakladatel
Opublikowany : 28/09/2015 2:12 pm
Veszmadar
(@veszmadar)
Active Member
Topic starter answered:
Re: Some of my prints

The brown, the green (for the vase) are pla.
The gray is abs. All from your shop.

The yellow and the white are abs from herz filament, a Hungarian company.

Opublikowany : 28/09/2015 3:41 pm
Veszmadar
(@veszmadar)
Active Member
Topic starter answered:
Re: Some of my prints

Soo... I'm back!

I am improving the lighting in my apartment.
These lights are made whit 4 or 8 power LEDs (1W), on 3mm thick laser cut ALU. I got 15 of them all over my place.
This is the old version, but i don't really like the plexi on it:
(Now that i look at the pictures, i dont like the cobwebs on it either... ) 🙂

This is the new 3d printed cover. Its made from clear PLA made by Herz Filaments (again). It was a nightmare to get it stick to the bed, but now i got it. I'm using the clear glass surface cleared with alcohol, 250°C/75°C. Some customization is coming.





The other lighting project is in the living room.
Its the old version, again the amount of light is not really enough.
1W power LEDs on 3mm ALU base hidden behind that edge.
There is 36 of them in the room.

I want to raise some of the lights above the border.The material is HERZ HIPS 280°C/100°C. This is the easiest material to print to date.

Opublikowany : 17/10/2015 6:19 pm
Share: