Notifiche
Cancella tutti
Pangolin
Had my eye on this one for a while, but there was no way my old printer was up to the job so it's had to wait for the MK2S to arrive.
Printed from Amaochan's model on Thingiverse. It's not the best print ever, but i'm quite pleased with how it turned out considering this is only the 3rd print from my new MK2S. I scaled it down to 75% and sliced at 0.2mm in Cura to reduce the print time from nearly a full day to around 6 hours. Printed the full body as 1 piece and the legs on their own. A couple of the joints were a bit tight, but everything broke free in the end and now it flexes nicely. 🙂
Postato : 22/04/2017 9:56 pm
Re: Pangolin
came out good nice job
Postato : 22/04/2017 9:57 pm