Notifiche
Cancella tutti
Medieval Castle - Rainbow
I am very happy with how this rainbow filament castle came out on my 3 week old MK3S kit. The model can be found on Thingiverse:
https://www.thingiverse.com/thing:2581233
Sliced in PrusaSlicer at .2mm layer height, the print took 45 hours and 41 minutes. Filament is Stronghero Splendid rainbow PLA.
Postato : 26/12/2019 3:11 am
RE: Medieval Castle - Rainbow
Wow, that turned out fantastic. Did you use supports?
Postato : 03/01/2020 2:41 pm
Topic starter
answered:
RE: Medieval Castle - Rainbow
@larry-r
No supports needed!
Postato : 03/01/2020 2:58 pm
Dave Avery hanno apprezzato
Postato : 04/01/2020 10:01 am
RE: Medieval Castle - Rainbow
Sure beats changing filaments for the colors!
(Your kit may be three weeks old - but you have more experience than that with 3D printers. Kids - don't try this at home until you have a few miles under your belt.)
Questo post è stato modificato 5 years fa da rmm200
Postato : 04/01/2020 5:59 pm
Topic starter
answered:
RE: Medieval Castle - Rainbow
@robert-rmm200
That is good advice!
Postato : 07/01/2020 6:43 am
RE: Medieval Castle - Rainbow
Epic print
Postato : 17/02/2020 6:52 pm
Topic starter
answered:
RE: Medieval Castle - Rainbow
@gnasher666
Thank you!
Postato : 18/02/2020 2:13 am