Halloween skull  

RE: Halloween skull

Very nice!

RE: Halloween skull

Thank you Charles. Here is another I did using a 0.25mm nozzle. Very happy with this but took twice as long to print!

Again, image above looks skewed but click on image to see correct view.

RE: Halloween skull

Posted by: @carlmaton

Hi,

Printed this with MK3S, PLA filament, 0.4mm nozzle and 0.1mm layers.  Minimal post processing, just support removal. Really happy with this:-) image below looks skewed but click on image to see correct view.

Congratulate!
The printer produces extraordinary prints, if the settings fits.

happy printing!

RE: Halloween skull

Really creative and fine work. I'm also planning to print that on my t shirt.

RE: Halloween skull

Wow! That looks really cool, good job

RE: Halloween skull

Pretty Bad Ass!

Assuming you are using an LED light? Would a regular bulb give off too much heat for PLA?

RE: Halloween skull

@fiddy-corp

Thank you. Yes, its an LED light. Agreed, a regular bulb may get too hot for PLA. Regards.

RE: Halloween skull

@karl-herbert

Thanks for your post and visiting:-)

RE: Halloween skull

@tshirtplusau

Thanks for your post and visiting:-)

RE: Halloween skull

@tiwi

Thanks for your post and visiting:-)

RE: Halloween skull

Amazing and creative work. Do you use led light?

LED tea light:-)

An LED tea light was used:-)