Got myself a 0.25 nozzle
Haven't cleaned up the model properly, was in a rush.
Just ripped off the supports and took it to work.
Re: Got myself a 0.25 nozzle
How long did that take to print? 6 days? 😆
Re: Got myself a 0.25 nozzle
Awesome print. Love the detail. did you try smoothing it at all later?
3D Printing is life www.3d-flight.com
Re: Got myself a 0.25 nozzle
For us new folks just getting into 3D printing too bad you couldn't create the same figure with the standard nozzle and show them side by side. I was just going to and will be posting my nozzle question in the MK3 section.
Re: Got myself a 0.25 nozzle
I had printed the same model on the MK2S with standard 0,4mm nozzle before.
I believe the layer height was 0,15 (Optimal) but could also have been 0,1, I don't remember.
Photos are not that great, but I think the difference comes out quite clearly. But it looks better in real life, the macro capabilities of the iPhone make it look worse than it is.
Re: Got myself a 0.25 nozzle
sweet, I have the 0.25 and a 0.15 nozzle that I want to try out now
Re: Got myself a 0.25 nozzle
Hi, I also received my 0.25mm nozzle and I want to experiment some prints. Did you use slic3r PE with standard 0.25mm settings ?
My youtube channel about the Prusa I3 MK2 https://www.youtube.com/channel/UCz-zQZcKcvEDdd9C9hOKYWg
Re: Got myself a 0.25 nozzle
alex.a5 I'm very very interested in this topic, have a look at my question in the Original Prusa i3 MK3 subforum: " Prusa Mk3 kit: when to install 0.25mm nozzle ?"
Could you please be kind enough to detail the complete procedure for buying and installing that 0.25 mm nozzle ?
Jacques
Re: Got myself a 0.25 nozzle
Haven't cleaned up the model properly, was in a rush.
Just ripped off the supports and took it to work.
Looks amazing. I have my .25 nozzle comming in today. When you printed did you just use the default settings for the .25 nozzle? Also what layer height was this printed at?