Notifications
Clear all
Dice Tower with a spring loaded trapdoor
I spent few evenings on the design but it ended up great. The Jail Tower is about 40h of printing time @ 0.15mm with 0.40mm nozzle.
No supports needed anywhere and the only hardware for it is a spring from a pen and an M3 bolt.
Posted : 02/03/2022 11:15 pm
RE: Dice Tower with a spring loaded trapdoor
Beautiful Prints, Nice job.
The Filament Whisperer
Posted : 02/03/2022 11:32 pm
Topic starter
answered:
RE: Dice Tower with a spring loaded trapdoor
Beautiful Prints, Nice job.
Thanks 🙂 The most difficult thing was to make it so that it is easy to assemble due to the bolt location for the trapdoor. I tried to make it so that it wouldn’t require a hole through the outer shell, but in the end I had to add a 4mm hole for the hex key.
Posted : 03/03/2022 12:01 am