Notifications
Clear all
Chameleon Air Ship
Chameleon Air Ship from Skies of Arcadia
I decided to start making ships from Skies of Acadia and this is the first test run of it.
Infill: 20%
Layer height: 0.20
Supports: Yes
Rafts: No
Filament: PLA
Took about 9 hours to print both half's, model was split down the middle and all the turrets and stuff where printed in place.
I had to glue a few back on when I dropped it removing the supports and a few of the turrets broke off but all in all it came out well.
Opublikowany : 03/07/2017 9:36 pm