Notifications
Clear all
Can holder for Harley
Here is a couple of pictures of a Can holder i draw in Tinkercad for my fathers Harley 🙂
Orange EasyABS 0,20 7% infill
Publié : 05/07/2017 10:19 pm
Re: Can holder for Harley
did you print the easyABS with your prusa inside an enclosure ?
looks quite smooth and pristine.
dem inscheniör is' nix zu schwör...
Publié : 05/07/2017 11:32 pm
Topic starter
answered:
Re: Can holder for Harley
Hi Jeff
No i did not use any sort of enclosure, Just heated up my mancave in the garage with my
homemade solar heater to around 27C and preheated the buildplate for about 10min, then
i turned of the solar heater/panel to minimize air movement before starting printing.
adding a picture of my solar heater 🙂
Publié : 06/07/2017 1:05 pm
Topic starter
answered:
Re: Can holder for Harley
And it looks like this mounted on the bike.
The "street glide" sign is also my design, printed in PLA so we will se how it will handle the heat from the engine 🙂
Publié : 06/07/2017 1:29 pm