3D printing a 3D printer Stand (well most of it..)
 
Notifications
Clear all

3D printing a 3D printer Stand (well most of it..)  

  RSS
vanweb
(@vanweb)
New Member
3D printing a 3D printer Stand (well most of it..)

I needed a stand for my new Prusa Mini 3D printer and since the printer contains many parts that are 3D printed I figured I would print as many parts for the stand as I could and use the same filament as was used on the printer. I hope you enjoy!

Here is an Instructable I wrote about the project: https://www.instructables.com/3D-Printing-a-3D-Printer-Stand/

This topic was modified 2 years temu by vanweb
Opublikowany : 13/07/2022 8:52 pm
deniyalsmith i jsw polubić
Swiss_Cheese
(@swiss_cheese)
Noble Member
RE: 3D printing a 3D printer Stand (well most of it..)

@vanweb

 

Very interesting!, I designed, and My company implemented something very similar, in a work environment for a factory as part of a recovery system several years ago. Good thinking if I do say so myself. I currently on a personal note, for two of my Prusa's (Mk3's) use them to keep the area under them clean and free of debris.

they work very well.

 

I must note for legal purposes, that my system differs from yours in several ways and does not include any kind of spool holder. Still nice job, and good thinking.

 

Swiss_Cheese

The Filament Whisperer

Opublikowany : 14/07/2022 1:26 am
Share: