Notifications
Clear all
Print image (nozzle height) first layer normal?
Hello,
I have the Prusa Mini and already a few successful prints behind me.
Now the filament was so stuck that I had to build the PTFE tube from the heatbreak.
After assembling I calibrated and would have said layer height fits, value Z axis -1890. The next time I tried to print, I had the following print image
On the one hand, the inner filling layer is not connected to the edge and the layers (front) are only partially fused together,
at the back of the print bed they lie next to each other? Is that normal? or is the nozzle set too high?
Thank you in advance for your help!
Greets Robert
Posted : 14/10/2025 7:06 am