Notifiche
Cancella tutti
[Prusa Connect Beta][Prusalink] Offline/Stuck after canceled print in PrusaSlicer
- PrusaLink type: Raspberry Pi Zero 2 W
- PrusaLink version: 0.6.0Printer type: MK3s
- Printer firmware version 3.10.1-4697
- PrusaSlicer version: PrusaSlicer-2.4.0+arm64-202112211601
During an 'upload and print' action from PrusaSlicer that I canceled during the upload (was still uploading) the connection got stuck.
A reboot of Prusalink using ssh did not resolve the issue. The MK3 is offline in Prusa Connect and Projects and Controls greyed out.
In Prusa Link is says that there is no valid token
I have no special talent. I am only passionately curious
Postato : 27/12/2021 12:34 pm
Topic starter
answered:
RE: [Prusa Connect Beta][Prusalink] Offline/Stuck after canceled print in PrusaSlicer
I was only able to resolve the issue by hard switching the printer off and on again using the power switch.
I have no special talent. I am only passionately curious
Postato : 27/12/2021 12:46 pm