Notifications
Clear all
Printer Stuck on "Finished" State and won't go to "Ready"
As the title states, a few of our MK3 printers sometimes won't go to a Ready state when sending the command and be stuck in the "Finished" state until we do a reset on the printer.
Publié : 22/01/2024 10:22 pm
RE: Printer Stuck on "Finished" State and won't go to "Ready"
That should be on a timeout. Well that's not good. Thanks for the report
Publié : 26/01/2024 11:49 am
fibreking a aimé
RE: Printer Stuck on "Finished" State and won't go to "Ready"
Altho i am not really sure why that happens, i checked the code, on every instruction that goes through, the code checks whether some time passed and if yes, it switches them off of Finished. Can you maybe figure out what to do to get the printer stuck? Any combo of things to try? PrusaLink version, usb/pins. Any details are appreciated
Publié : 08/02/2024 3:20 pm