Notifications
Clear all
Filament runout did not allow reloading
Firmware 6.1.4 that came loaded onto my mk4s kit.
filament ran out about 20% through a print. It unloaded correctly and I pressed “YES” when prompted by the display of the filament was unloaded successfully.
Then the screen displayed 0% and asked me to unload filament again. I was not able to reload the new filament spool. I was forced to abort the print and wasted many g of filament.
After restarting the machine I was able to load filament with absolutely no issues. So there was not filament stuck in the sensor.
Posted : 23/12/2024 2:30 am