Bug printing multimaterial support interface en PSLICER?
Possible bug in PSLICER: I want to print PLA with support interface in PETG. Immediately after printing the last layer of the PETG interface, the first layer of PLA is printed too fast over the PETG layer (at the same speed as the infill speed of the rest of the piece, let's say 100mm/s). This causes the PLA to detach immediately. However, in ORCA SLICER, by default, the infill speed of the first PLA layer (right above the last PETG interface layer) is much slower (about 20mm/s). I don't see any option in PSLICER to reduce that speed.
One more thing (perhaps the option is available but not enabled by default). In ORCA, before printing the first PETG layer (that is, between the support and the interface), it prints a final smooth layer of PLA. However, in PSLICER, the first PETG layer is printed directly on top of the support (which is not a smooth surface but has gaps), forcing me to reduce the support spacing to improve the adhesion of the interface.
I think I was clear, but if images are needed, let me know.