Benachrichtigungen
Alles löschen

Z-Axis Too High  

  RSS
nfritsch
(@nfritsch)
New Member
Z-Axis Too High

Mini+, Trying to run first calibration, and my Z-axis is too high, even at -2.000. I used the credit card method for adjusting the MINDA, and was still too high. I then used a folded up piece of paper, still too high. I get an okay rectangle, but I can still see minor gaps in the lines. And when I pull the rectangle up, I can spread the lines apart very easily. I can't go any lower with the MINDA unless I put it right up against the heat shield.

Any suggestions for how to lower the nozzle below 2.0, or make the proper adjustments?

Dieses Thema wurde geändert Vor 3 years von nfritsch
Veröffentlicht : 12/02/2021 2:13 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Z-Axis Too High

reset live Z to zero fore safety, Raise the minda a little!
1 turn will reduce live z by 1mm. (1.ooo on the live Z)

minda / liveZ relationship is effectively reverse to what you may initially imagine!

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Veröffentlicht : 12/02/2021 12:27 pm
Du gefällt das
nfritsch
(@nfritsch)
New Member
Themenstarter answered:
RE: Z-Axis Too High

Thank you so much @joantabb. I adjusted the MINDA up, and now I'm successfully printing at -0.635, much better than before. I appreciate your help, and quick response.

Veröffentlicht : 12/02/2021 4:06 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Z-Axis Too High

@nfritsch

Good news. 

Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Veröffentlicht : 13/02/2021 2:06 am
Teilen: