Notifications
Clear all
Y axis going off bed in first layer calibration
Hello,
I just set up my new Mini printer and it went through the wizard until First Layer Calibration. It is probing the print bed and gets through the first 3 rows, but on the fourth the bed is advanced too far and the probe is off the bed and the calibration fails. Not sure what could be causing the problem?
Publié : 19/11/2020 6:31 pm
RE: Y axis going off bed in first layer calibration
hello cdtdata
my mini made same mistake in first row point 3.
Steelplate is damaged and look loike prepairing for a drill.
Printer is used 2. day. :-(.
I also dont know why.
Regards
Publié : 20/11/2020 6:00 pm
RE: Y axis going off bed in first layer calibration
Use the web chat on the e-shop page to talk to support. The site is very busy today with all the black Friday orders, so it may be better to try early next week!
Publié : 27/11/2020 1:28 pm