Notifications
Clear all

Y axis going off bed in first layer calibration  

  RSS
CdtData
(@cdtdata)
New Member
Y axis going off bed in first layer calibration

Hello,

I just set up my new Mini printer and it went through the wizard until First Layer Calibration.  It is probing the print bed and gets through the first 3 rows, but on the fourth the bed is advanced too far and the probe is off the bed and the calibration fails.  Not sure what could be causing the problem?

Posted : 19/11/2020 6:31 pm
ProjektTeam
(@projektteam)
New Member
RE: Y axis going off bed in first layer calibration

hello cdtdata

my mini made same mistake in first row point 3.

Steelplate is damaged and look loike prepairing for a drill.

Printer is used 2. day. :-(.

I also dont know why.

Regards 

Posted : 20/11/2020 6:00 pm
Gordon W
(@gordon-w)
Reputable Member
RE: Y axis going off bed in first layer calibration

Use the web chat on the e-shop page to talk to support. The site is very busy today with all the black Friday orders, so it may be better to try early next week!

Posted : 27/11/2020 1:28 pm
Share: