Notifications
Clear all
What is the cause for this printing issue?
Hi there, the model is a cube printed in PLA and I have tried different batches with the same issue shown in the picture. Any ideas about what I have to adjust?
The belts for the XY axis seem to have the right tension.
Posted : 24/12/2022 12:51 pm
Your picture is a little blurred: Is that intended to be a smooth walled cube and the horizontal lines are artifacts? A clearer picture would help us.
Cheerio,
Posted : 24/12/2022 4:11 pm
Topic starter
answered:
RE:
Here it goes a picture with some more detail. Yes, it is suppose to be a hollow test cube with just one .4mm layer as walls. The surface should be smooth, without the "displaced" lines. Thanks in advance!
Posted : 24/12/2022 7:17 pm
RE: What is the cause for this printing issue?
Check your extruder gear, looks like your gear is dirty and not align.
Posted : 24/12/2022 8:28 pm
Annuminas liked