Very high first layer Z on new Mini
Hi
I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal -1.95
As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?
Thanks
Graham
RE: Very high first layer Z on new Mini
Hi
I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal -1.95
As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?
Thanks
Graham
Hello and welcome to the Prusaforum!
I would adjust the MINDA - look here: https://help.prusa3d.com/en/guide/troubleshooting-the-mini-assembly_7848/ (STEP 2)!
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Very high first layer Z on new Mini
@karl-herbert
Ok thanks Karl (MINDA eh ! Ive still got my 3i head on 🙂
Graham
RE: Very high first layer Z on new Mini
That sorted it.
The manufacturers setting of the MINDA probe was set about 1mm to low.
Graham