Notifications
Clear all

Very high first layer Z on new Mini  

  RSS
Graham
(@graham-3)
Eminent Member
Very high first layer Z on new Mini

Hi

I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal  -1.95

As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?

Thanks

Graham

Posted : 15/09/2020 6:52 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Very high first layer Z on new Mini
Posted by: @graham-l2

Hi

I have just assembled my new mini and the Z level is very high (or is that low) to get the correct first layer cal  -1.95

As its factory set should I jump in and adjust the PINDA height or be looking at somthing else first?

Thanks

Graham

Hello and welcome to the Prusaforum!

I would adjust the MINDA - look here: https://help.prusa3d.com/en/guide/troubleshooting-the-mini-assembly_7848/ (STEP 2)!

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 15/09/2020 6:55 pm
Graham
(@graham-3)
Eminent Member
Topic starter answered:
RE: Very high first layer Z on new Mini

@karl-herbert

Ok thanks Karl (MINDA eh ! Ive still got my 3i head on 🙂

Graham

 

Posted : 15/09/2020 6:58 pm
Graham
(@graham-3)
Eminent Member
Topic starter answered:
RE: Very high first layer Z on new Mini

That sorted it.

The manufacturers setting of the MINDA probe was set about 1mm to low.

Graham

Posted : 17/09/2020 6:11 pm
Share: