Notifications
Clear all
Squeaking during quick retractions
I set up my mini + a few days ago and have enjoyed printing with it thus far. I did notice a squeaking during quick, sequential retractions last night though. The sound seems to be originating from the filament sensor near the end with the screw. I might have it too tight but I am curious if anyone else has come across this.
Publié : 24/12/2020 5:20 pm
RE: Squeaking during quick retractions
Mine made similar noise the first couple of prints, but it went away after about 5 hours of printing.
Publié : 25/12/2020 11:53 am
Topic starter
answered:
RE: Squeaking during quick retractions
Mine made similar noise the first couple of prints, but it went away after about 5 hours of printing.
Mine has stopped squeaking now as well. Thanks for your insight.
Publié : 31/12/2020 4:06 am