Notifications
Clear all

Squeaking during quick retractions  

  RSS
obv
 obv
(@obv)
Eminent Member
Squeaking during quick retractions

I set up my mini + a few days ago and have enjoyed printing with it thus far. I did notice a squeaking during quick, sequential retractions last night though. The sound seems to be originating from the filament sensor near the end with the screw. I might have it too tight but I am curious if anyone else has come across this.

Posted : 24/12/2020 5:20 pm
avh
 avh
(@avh)
Eminent Member
RE: Squeaking during quick retractions

Mine made similar noise the first couple of prints, but it went away after about 5 hours of printing.

Posted : 25/12/2020 11:53 am
obv
 obv
(@obv)
Eminent Member
Topic starter answered:
RE: Squeaking during quick retractions
Posted by: @avh

Mine made similar noise the first couple of prints, but it went away after about 5 hours of printing.

Mine has stopped squeaking now as well. Thanks for your insight.

Posted : 31/12/2020 4:06 am
Share: