Notifications
Clear all
Selftest: Bailout at ~180°C
Hi there,
I've just assembled the Mini, looked good so far.
However, the self test is failing at ~180°C, where the hotend target temp suddenly is set to 0°C, and then, selftest fails.
Firmware 4.0.5 which is the newest one.
Any hints?
Thanks in Advance,
Stefan
Posted : 02/07/2020 11:54 am
RE: Selftest: Bailout at ~180°C
Are you doing the Self test with the metal plate on the bed? It needs to be on if not.. took me several attempts until I realised why it kept failing
My Mini has: A SuperPINDA + Bondtech Heatbreak + Bondtech Extruder installed
Posted : 02/07/2020 12:11 pm
Stefan Hanke liked
Topic starter
answered:
RE: Selftest: Bailout at ~180°C
D'oh - thank you very much 🙂 after 1st layer calibration, it's working fine now.
Posted : 02/07/2020 6:03 pm