Notifications
Clear all
Retraction settings for PLA on the MINI
I’m getting some very good results on the Mini with one exception. I’m getting bumps on the perimeter at the layer changes using PLA. These are noticeably worse than I see with the MK3S. I can’t seem to find some good retraction settings to reduce those. I asked this before but was having other issues that have since been resolved. There were suggestions to use Simplify3D but I would rather try getting it tuned in Prusaslicer. Can anyone provide any input on settingS that might reduce these bumps? I’m guessing it’s some mystic combination of the retraction settings.
Thank you.
Napsal : 22/03/2020 6:49 am