Notifiche
Cancella tutti
Problems with first layer - lines are not connected
Today I got my Prusa 3d mini and after assembly, during first layer calibration we lowered the height all the way to -2mm, which is the lowest it can go, but it still not connected, as you can see on the images.
Can you help me?
Best Answer by Bob:
Raise the MINDA probe, it's too low. Take a look at this knowledge guide.
https://help.prusa3d.com/en/guide/how-to-adjust-the-height-of-the-m-i-n-d-a-sensor-mini_154547
Cheers
-Bob
Postato : 07/02/2022 6:26 pm
RE: Problems with first layer - lines are not connected
Raise the MINDA probe, it's too low. Take a look at this knowledge guide.
https://help.prusa3d.com/en/guide/how-to-adjust-the-height-of-the-m-i-n-d-a-sensor-mini_154547
Cheers
-Bob
Prusa I3 Mk2 kit upgraded to Mk2.5s, Ender3 with many mods, Prusa Mini kit with Bondtech heat break, Prusa I3 Mk3s+ kit
Postato : 08/02/2022 6:50 pm
obiady_impet0h hanno apprezzato
Topic starter
answered:
RE: Problems with first layer - lines are not connected
This solved my problem. Thanks.
Postato : 08/02/2022 7:09 pm