Notifications
Clear all
print quality issue
What causes the "scarring" on the surface of this print? Printed with Prusament PLA. Sliced in PrusaSlicer on ultra detail 0.05 mm
Opublikowany : 22/03/2020 2:08 pm
RE: print quality issue
Are you using 4.0.4 firmware ?
There is a slight under extrusion issue with this version, apparently fixed in the next one (which is currently an RC version)
S
Opublikowany : 22/03/2020 2:15 pm
Topic starter
answered:
RE: print quality issue
@steve-4
Yes I'm using the 4.0.4 fw, will try the RC version.
Opublikowany : 22/03/2020 4:10 pm