Avisos
Vaciar todo
Mini+ starts doing wierd stuff while printing
Hi all,
so I have a problem with mini+.
The first couple of layers prints fine and then like it starts to push more filament than needed, the
model gets bumpy and the nozzle starts hitting those bumps and it gets worse and worse.
What to do?
Respondido : 11/09/2022 8:29 am
Dry your filament.
If there are still problems run a first layer Z calibration and show us the resulting print *on the print sheet*.
Cheerio,
Respondido : 11/09/2022 10:57 am
RE: Mini+ starts doing wierd stuff while printing
Printing PETG at PLA temperatures?
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Respondido : 12/09/2022 11:15 am