Notifications
Clear all

Mini+ starts doing wierd stuff while printing  

  RSS
magloviti
(@magloviti)
New Member
Mini+ starts doing wierd stuff while printing

Hi all,

so I have a problem with mini+.

The first couple of layers prints fine and then like it starts to push more filament than needed, the

model gets bumpy and the nozzle starts hitting those bumps and it gets worse and worse.

What to do?

Posted : 11/09/2022 8:29 am
Diem
 Diem
(@diem)
Illustrious Member

Dry your filament.

If there are still problems run a first layer Z calibration and show us the resulting print *on the print sheet*.

Cheerio,

Posted : 11/09/2022 10:57 am
FoxRun3D
(@foxrun3d)
Famed Member
RE: Mini+ starts doing wierd stuff while printing

Printing PETG at PLA temperatures? 

Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...

Posted : 12/09/2022 11:15 am
Share: