Mini+ has a massive fail in exact same spot.
I am trying to figure out how to go about troubleshooting this. I am not home when it happens but I've had 2 of the exact same prints fail, knock the print off the print bed, and I am greeted with a spaghetti monster. In this case, I'd like to think of it as a spider web as it'd be more fitting.
Does anyone have any ideas on where I should start with trying to figure this out? The print looks really good up until that point and even after a partial failure it still printed a bunch of layers before presumedly getting knocked off the bed.
This is a pre-assembled Prusa Mini+ I received quite recently. This is the second print I've attempted, the first being an articulated dragon that came out really well.
RE: Mini+ has a massive fail in exact same spot.
What does the first layer look like? Have you checked that the printer is square & bed is level?
Mini+ (kit) - Revo Micro | Antler Cooling | WiFi (4.4.0RC1)