Kink / Defect in PTFE-tube
I wonder if anyone else have had any defects or kinks on the inside of the long ptfe-tube for the mini-kit?
When i feed filament thru it there is significant resistance ( slightly less from one end then the other) at the spot where the defects are.
The filament will push thru, but only with force.
I have not contacted prusa yet (not finished with build so dont know if it will impact the functionality).
One image is with filament in tube, one without.
Prusa Mini+ kit. BondTech extruder. FW 5.1.2
Prusa MK3S+ kit. Stock. FW 3.11.0
Prusa MK3S+, used. Stock. FW 3.13.3
RE: Kink / Defect in PTFE-tube
For those interested, so far it has not made any trouble when printing PLA atleast.
Prusa Mini+ kit. BondTech extruder. FW 5.1.2
Prusa MK3S+ kit. Stock. FW 3.11.0
Prusa MK3S+, used. Stock. FW 3.13.3