First Layer Calibration issues
Hey there,
I've tried calibrating the z height from 0.0, down to -0.030, with similar results each time;
How can I make this better?
RE: First Layer Calibration issues
Z-offset range goes from 0 all the way down to -2.000. So you should try to decrease Z offset more. Depending on how high your PINDA sensor is mounted, you can expect good first layer somewhere between -0.500 and -1.500.
[Mini+] [MK3S+BEAR]
RE: First Layer Calibration issues
I've tried calibrating the z height from 0.0, down to -0.030, with similar results each time; How can I make this better?
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
RE: First Layer Calibration issues
@bogdanh
Thanks!
I tried your suggestion and indeed I had to set the z height much lower. -1.25 was the ticket to a good print.
RE: First Layer Calibration issues
Make that -1.5