First Layer Calibration Doesn't Remove Gaps
I am stuck at the first layer calibration and have so far gotten the straight lines and corners looking right. However the gaps in the little square at the end persist through +6 runs of this test. I have the 3-piece assembly kit along with the filament sensor.
Could someone please help me?
Helpful answers are appreciated. I usually respond to Tweets directed at me.OS: Raspberry Pi OS & Windows 10. Programming Languages: Python & Java
Z Height
If you're still seeing gaps, it's likely that your nozzle is still too high. Do you have a picture, so we can get a better idea of the problem?
Found the Right Height
I found the right height later on, here’s a pic of the included Prusa logo test print:
Helpful answers are appreciated. I usually respond to Tweets directed at me.OS: Raspberry Pi OS & Windows 10. Programming Languages: Python & Java