Notifications
Clear all

Bed not centered?  

  RSS
huleboer
(@huleboer)
New Member
Bed not centered?

Hi.

I have an issue where the psysical bed seems to have another position than the bed in prusaslicer. 

When I want to print something hat goes right to the edge it creates a problem. 

The print is a bit too much to the right and quite a lot more towards the top.

Any idea on how I can calibrate this?

Posted : 30/12/2021 8:48 am
Bob
 Bob
(@bob-2)
Reputable Member
RE: Bed not centered?

It doesn't look like a centering problem based on your photos, the fence looks like it's printed in the right place.  It looks like the model is over sized as it's touching or over hanging the fence.  When was the last time you updated Prusa Slicer?

Cheers

-Bob

Prusa I3 Mk2 kit upgraded to Mk2.5s, Ender3 with many mods, Prusa Mini kit with Bondtech heat break, Prusa I3 Mk3s+ kit

Posted : 01/01/2022 9:32 pm
huleboer
(@huleboer)
New Member
Topic starter answered:
RE: Bed not centered?

The model looks oversized because it's real and not a 2d representation like in the slicer. The measurements are as they should be. 

I've tried with other models as well there the print head would hit the screws that the bed is aligned with. 

 

Slicer is 2.3.3 and printer is 4.3.3

Posted : 01/01/2022 9:37 pm
Share: