Notifiche
Cancella tutti

Bed leveling vs filament extrusion issue?  

  RSS
docforestal
(@docforestal)
Active Member
Bed leveling vs filament extrusion issue?


Reposting asking slightly different way as previous post- I’m not a techie but getting pretty frustrated.

initial calibration and wizard all good, some pieces print ok some string or pull depending on location on bed- not worried about sticking but that on initial calibration filament goes down consistent but on Jeff Jordan method it appears filament not coming out on parts of x,y axis? This has left super thin filament I cannot get off the bed- started scraping (cleaning with dawn and ipa) new bed coming as this one is ruined but want to fix this

if the z axiswas too close or too high would look different I think

any help please- thanks

Postato : 24/04/2023 5:47 pm
Condividi: