Bed Level Issues
I'm having an issue with a non-level bed on my mini. I've run bed levelling in calibration several times but have the problem shown in the picture, where part of the print is thinner on one side.
The Z-calibration doesn't seem to show this, but it's hard to tell as this are of the bed (near right) is not well represented in the Z-calibration process.
Was thinking of inserting some folded paper under the far left corner to try to level it all out.
Any pointers appreciated! Thanks!!!
RE: Bed Level Issues
I had a similar problem until I applied this mod: https://forum.prusa3d.com/forum/user-mods-octoprint-enclosures-nozzles/prusa-mini-silicone-bed-leveling-mod/
The automatic bed leveling can only compensate for so much...
Prusa Mini Silicone Bed Leveling Mod: https://bbbenji.github.io/PMSBLM/