3x3 Calibration on Mini consistency issue
Somewhat new to 3D printing so trying to figure this out researching first, but can't seem to find a solution. I have the first layer calibration down good with a Z offset at -0.820. When I print larger items that span the entire build, the results are a little sketchy but end up "usable". I downloaded (from printables.com) the 3x3 calibration file and printed it. Some parts look really good and other corners are meh...not so great. What can I do to get a consistent print across the build plate? Are my expectations too high?
RE:
I would be very pleased with that result.
Have seen it worse, and that on my own Mini + 😊
RE: 3x3 Calibration on Mini consistency issue
It looks like your left side is lower than your right side, so check the squaring of the XZ axis: https://help.prusa3d.com/article/squaring-your-mini_158518
RE: 3x3 Calibration on Mini consistency issue
Thank you for the link. Working to understand the 3D printing vernacular and all the components...so I can search for answers.