Prusa3D Forum

Notifications

Clear all

ZX Printer

Skupina: Registrovaný

Přidal se: 2019/12/28

New Member

	@jweaver Screw was ok, but the hint regarding the obvious wa... In forum General discussion, announcements and releases	před 5 years
	Is there anything in the new firmware that might cause layer... In forum General discussion, announcements and releases	před 5 years
	This may be a totally stupid comment, but I noticed I had to... In forum Hardware, firmware and software help	před 5 years
	No regrets at all. I am pretty happy with the printer and ex... In forum General discussion, announcements and releases	před 5 years

Fórum Statistiky

565 Fóra

64.6 K Témata

452.2 K Příspěvky

23 Online

71.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed